OkayFreedom

What's new in this version:

Bug-fixes:
- Fixed issues with support no longer generated on some parts of the model. Support Stair Steps has caused some support to be missing where it touches the build plate or where it's resting on a shallow surface. It should be complete again
- Fixed multiple different issues with tree support, where branches would intersect with the model, the wouldn't keep distance when resting on the model, or when printing with Spiralize mode
- Fixed an issue where Cubic Subdivision infill didn't move along with the model
- Cubic Subdivision will now rotate according to the Infill Line Directions setting. Contributed by smartavionics
- X-ray view is now red again, instead of translucent green
- Improved wording of the "Discard/Keep Changes" dialog for clarity
- Models assigned to extruders >4 are visible again in layer view
- Fixed an issue when importing images if the "Base" setting was greater than "Height"
- Cura now outputs a command to cool down the build plate for the second object in one-at-a-time mode even if the Initial Layer Build Plate Temperature is 0
- Distance between infill and walls and between infill and skin is corrected when using Infill Layer Thickness
- Fixed a crash when Coasting Minimum Volume is set to 0
- The usable build volume will no longer be shrunk unnecessarily when not using any adhesion, but using a prime tower with a brim
- Fixed a slicing crash when combining Randomize Infill Start with an even number for Infill Line Multiplier
- Improved reduction of model resolution. The Maximum Resolution and Deviation settings should now be more accurate and no longer behave differently in one corner of the model
- Removed an unintended gap when something was resting on an ironed surface
- Fix skirt printing out of order, causing unnecessary travel moves. Contributed by smartavionics
- A fix was added by smartavionics which removes unnecessary long moves that travel towards the outer wall
- It wasn't possible to connect to a network printer if two network plugins were enabled simultaneously. Now made possible by Loociano
- Support settings are now visible when you have support disabled, but a support mesh is present in the scene. Fixed by fieldOfView
- Fix printing speed after performing a retraction when using the stretch post-processing script. Contributed by sgtnoodle
- Prevent tool panels from overlapping with scene information. Fix made by smartavionics
- The values of the machine settings would look cut-off on some Linux distributions. Now fixed by smartavionics
- Fixed settings sometimes not appearing if they belong to a checkbox setting that is enabled by default (e.g. retraction settings belonging to Enable Retraction)
- We cleaned up our “About...” dialog. It is now up to date
- Improve performance of loading profile metadata. This fix improves the start-up time of Cura
- When loading images, the translucency and linear options were swapped. Translucency should now again be tuned for lithophanes, and linear for a height map. Contributed by michalsc
- Retractions in travel move to next layer were sometimes omitted, but that's fixed now. Contributed by smartavionics
- Fix initial layer thickness when empty initial layers are removed. Contributed by smartavionics
- If Brim Replaces Support is enabled, the brim will now also replace support interface